Blend mode (Destination In) in Chrome & Node.

Hi I have a little problem with the blend mode (Destination In) when I preview in Node & Chrome. I have not tried to export the project. Made some searches here but to no avail. Is it possible that I have missed that blend modes not work in chrome or node? Or am I doing it wrong?

I have a sprite with "Destination In" to be masking a sprite under it in the same layer.

Can you post a capx and a bit more about how you want the masking to work? When you say " to be masking a sprite under it" you mean that you want the first Sprite to mask out (make it invisible) the second Sprite?

Thank you eli0s for your reply.

Well what I'm trying to achieve is to mask a sprite that will serve as a cooldown.

It should look like this:

These are the pieces.

And this is what the Destination In sprite look like.

I'm missing something aren't I because Destination In should mask whatever lies behind it on the same layer. Wrong?

Make sure that in the layer's properties, "Force own texture" is set to "Yes". Also make sure that the z-order of the sprites is correct based on your chosen blend mode.

Monumental I am still not sure what exactly you're after. You want the "green bar" Sprite to cut a hole on the "radar" Sprite...? If yes, Perhaps an other blending mode is needed. Check the capx.

Thank you GeometriX & eli0s you are very helpful. The fault was mine in one of the many events I asked the cooldown sprite to lay behind the radar pegs and not the mask. Uploaded a build on petrolheadtactics.com force own texture was helpful. Thank you again!