Bullet Behaviour Stops

Get help using Construct 2

Post » Sun Jul 28, 2013 4:16 am

Hello everybody,

I'm new here and I'm still getting used to Construct 2. I'm trying to simulate an object falling down when there's any other object touching it. To do that, I'm using the bullet behaviour and I've set it's angle to 90 degrees.

It happens that when the bullet behaviour is enabled, it just runs for a little moment and then stops. I think I've made some dumb mistake (I hope so) but I simply can't see where. Could you help me?

Here it goes the link of the .capx file:

https://www.dropbox.com/s/qxtgamkbxtbjo18/Bullet-is-stopping.capx

Thanks!
B
9
G
1
Posts: 11
Reputation: 659

Post » Sun Jul 28, 2013 11:12 am

Hey mate,

The problem is in the 'stones overlapping' group. While the stone is overlapping the those border objects it disables the bullet. So if you just toggle 'set bullet disabled' off you will see the stone continues to drop. Hope that helps!
B
28
S
8
G
5
Posts: 429
Reputation: 6,997

Post » Sun Jul 28, 2013 3:41 pm

I can't believe it was just that simple!! Thank you a lot!
B
9
G
1
Posts: 11
Reputation: 659


Return to How do I....?

Who is online

Users browsing this forum: justifun, tarek2 and 4 guests