How do I get "node sigserv.js" to work?

Get help using Construct 2

Post » Wed Jan 21, 2015 1:04 am

I followed the directions in the signalling server's instruction but when I try to put "node sigserv.js" in putty to run my server it just replies that the command node was not found. Do I have to somehow install the node.js dependencies on my server? If this is the case, how do I do that?
B
45
S
13
G
1
Posts: 236
Reputation: 4,010

Post » Wed Jan 21, 2015 11:35 am

If your system doesn't recognise 'node', then you need to install node.js or replace the 'node' part of the command with the full path to the node.js executable.
Scirra Founder
B
399
S
236
G
89
Posts: 24,519
Reputation: 195,361

Post » Wed Jan 21, 2015 6:45 pm

Thanks Ashley! I tried and it tells me access is denied so I'm doing tech support in a little bit to see what the deal is with that but I take it your method works because it didn't say command was not found. I will post an additional reply if I need further assistance.
B
45
S
13
G
1
Posts: 236
Reputation: 4,010


Return to How do I....?

Who is online

Users browsing this forum: No registered users and 6 guests