Replacement for "scale inner" by mannual scaling

Discussion and feedback on Construct 2

Post » Tue May 09, 2017 10:24 am

Hello friends!
I have 960x1280 portrait project with "Scale inner". The main content is located at 720X1280 that is, the aspect is 9:16.
When I created the project, I did not think about narrow phones, and now i have such situation:
Image

In principle, now I would be satisfied with the solution:
the project does not change except that "Scale inner" is replaced with a manual scale,
which behaves exactly in same way if the aspect ratio of the phone is greater than 9 by 16,
otherwise the picture decreases so the whole content fits in width even with voids from above and below:Image

For this, I set the option "Fullscreen in browser" in the "Crop", and at the start of the application I run the following actions:
Image

But it did not work. Even in the case of an aspect larger than 9 by 16, the image is huge, although the "scale_common" is calculated correctly. What am I doing wrong?
B
16
S
6
G
1
Posts: 109
Reputation: 1,952

Return to Construct 2 General

Who is online

Users browsing this forum: Unconnected and 12 guests