Resolution and changes in dimensions

Get help using Construct 2

Post » Wed Nov 13, 2013 6:09 am

Hi, I'm new here, but I'm having fun. I completed a couple of tutorials so far and everything goes well.

I was looking into the code from the jumper and I have been trying to set it up as 1920x1080, but I have not been able to figure it out why the actual platform is appearing in the middle (must be something very obvious). I already changed the values in Project and in the Layout.

Another question... I keep reading about setting up a 16:9 resolution. A read on a tutorial to avoid designing for a resolution, instead design for a ratio. However, C2 does require a resolution, correct? Should I use 1920x1080, so if it is lower, the image should shrink? or should I use a lower resolution with 2x size of assets?

Here's the jumper .capx

Thanks!!!
B
8
S
3
G
1
Posts: 135
Reputation: 2,209

Post » Fri Nov 15, 2013 7:06 am

Added the correct .capxjumper.capx

I believe the issue is with the viewport (values are showing me that they start at 800), but I was not able to find a tutorial looking just by viewport.
B
8
S
3
G
1
Posts: 135
Reputation: 2,209


Return to How do I....?

Who is online

Users browsing this forum: Blendi1223, gskunk, richcoz81, tarek2 and 40 guests