Restarting Pathfinding

Get help using Construct 2

Post » Wed Mar 13, 2013 4:05 pm

Basically what happens after a collision is: pathfinding gets turned off, custom movement is used to simulate the 'bounce' caused by the collision, and then custom acceleration is added to decelerate the 'bounce'.

Once the enemy's speed reaches zero or lower (due to the deceleration), it should start pathfinding again. However, it doesn't, and I can't figure out why.

Here is the relevant events area:


ImpulseCollision.capx
Project Lead of Zems Online Card Game

Producer at Impulse Limited
B
18
S
6
G
3
Posts: 677
Reputation: 5,194

Return to How do I....?

Who is online

Users browsing this forum: fredriksthlm, marekmk and 1 guest