Wait that bus

Get help using Construct 2

Post » Sun Nov 01, 2015 8:38 pm

so all my code work good

How do I slow down the events so that i can check on the picking of instance because I am using Target set position to make sure that each sprite is doing its job correctly but the problem I have is that contruct is going too fast for my eyes to keep up.

It feels like the Event bus is moving at lightspeed.....i cant see the events running at that fast even with debug

I tried using various wait command and place em at the end but problem is its breaking all the rules and causing so much headaces
B
52
S
24
G
6
Posts: 391
Reputation: 7,845

Post » Sun Nov 01, 2015 8:51 pm

Could you set the timescale down?
B
22
S
7
G
1
Posts: 90
Reputation: 2,045

Post » Sun Nov 01, 2015 10:01 pm

Like IamHarlow suggested, put a timescale=25 debug line in your on-start and see if that slows it down enough for you to see.

The problem is event sheets fire off at 60 times a second, you can slow this down by using every-x-seconds instead of every-tick and something like 0.1 seconds (fast but not blindingly fast) in your constantly running events
Check out my completed games on the Arcade! Capt. Doe Save the Universe! & Clicker Wizard!
B
66
S
17
G
8
Posts: 637
Reputation: 9,370

Post » Mon Nov 02, 2015 2:40 am

Umm I tried to do what you guys suggested but It seem like one event Is firing too fast even with timescale down to .01 I cant debug or see if it working or not because according to my logic it isnt working but i cant see what it is not working and where i can improve.

Imma try to create an invisible sprite animation and use on finished command to see if i can slow it down
B
52
S
24
G
6
Posts: 391
Reputation: 7,845

Post » Mon Nov 02, 2015 6:31 am

I think what it sounds like you are looking for is "Step."

https://www.scirra.com/manual/169/debugger

Set a break point, and press "step" to advance frame by frame. You will see the Events highlighted as they are executing.
B
230
S
62
G
33
Posts: 902
Reputation: 40,319


Return to How do I....?

Who is online

Users browsing this forum: namaewayukidesu and 8 guests